Table of Contents
Advertisement
Edge Pitch
2-27-5
Changing Detailed Conditions
Detailed conditions
Edge level : [ 10 ]%
Min. level : [
End
Threshold value for finding an edge (0 to 100).
If the measured number of objects is less than
the actual number of objects, set the edge
level (or the minimum level) to a smaller
value.If the measured number of objects is
greater than the actual number of objects,
set the edge level (or the minimum level)
to a larger value.
Edges are detected in the following way:
1. The density differentiation for the entire
measurement range is obtained.
2. The points corresponding to the maximums
and minimums that exceed the edge level
setting are detected as edges.
Change the detailed conditions when the measurement results are unstable.
Normally, these conditions can be left on the default settings.
If any of the settings are changed, take actual measurements to confirm that
they are correct.
To prevent incorrect detection due to noise (0 to 255).
5 ]
(If the density variation is less than the minimum value,
it will be considered to be noise.)
1.
Select Detailed conditions.
0.Edge pitch
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
2.
Change the settings.
3.
Select End.
The settings will be registered and the screen in (1.) will return.
Example
100%
20%
0%
20%
100%
1 edge
Measurement conditions
Region
Judgement conditions
Detailed conditions
Coordinate mode
Edge level : [ 10 ]%
Min. level : [
5 ]
End
Section 2-27
Measurement region
Edge level
Edge level
2-27-(7)
Advertisement
Chapters
Table of Contents
