Omron F250-UME Software Manual page 562

Lot Number OCV 1
STEP 4: Changing Extract Methods
CHECK
2-24-(9)
Change the extract method if the numbers are not extracted accurately. Nor-
mally, the method can be left on the default setting. After changing the setting,
perform a measurement to check that the numbers can still be extracted cor-
rectly.
The extract method setting is enabled only for regions for which automatic
extraction is selected under Measurement conditions/Extract method.
1. Select Extract method.
Trimming conditions
The Extract Method Settings Screen will be displayed.
Extract method
2. Change the settings.
3. Select End.
The settings will be registered and the screen in (1.) will return.
Compensate image
Shading
Binary
Extract method
Dilate level
Noise conditions
: Gap search
Method
:
Forced extraction
:
From left
Direction
End
Section 2-24
OFF