Omron F250-UME Software Manual page 990

FAQ
General Measurements
Question
QUEST Character Verification
Can the characters that are read (A to Z, 0 to 9, :, /, _
(space)) be output directly as text strings to an external
divide?
EC Positioning
Can an edge-extracted image be captured?
Measurement Support
Question
How do I set a formula with more than
64 characters in an expression?
Is there any way to count NG images? Yes, by using the Calculation processing item. Use the following proce-
Results Display
Question
Can figures display with the Display Figure processing
item be changed through serial communications?
7-(10)
Turn ON the Output results under the Measurement
conditions. The text strings will be output through the
serial port.
Refer to
No. Edge-extracted images are produced by process-
ing camera buffer images, so they cannot be captured.
Only images input through the Camera Image process-
ing item can be captured.
Set up an additional expression and an expression that will reference
the additional expression.
Refer to .
dure.
Example: Counted NG images for Binary Defect
1. Set a Calculation unit after the Binary Defect unit.
0.Scn 0=SET=
0.Camera image
1.Binary defect
2.Calculation
3.
ENT:Set SFT+ESC:Edit
2. Set the following expression for calculation 0 in the Calculation unit:
U2.D00-U1.JG
Refer to .
CHECK
To output the count to an external device, change the Calculation pro-
cessing item to a DO Data or a Normal Data processing item (depend-
ing on where the data is to be output.)
Refer to or
No, they cannot be changed through serial communi-
cations and must be changed from the Console.
Refer to
Answer
Answer
Judgement result
-
1: NG, 0: OK
.
Answer
.
Section 7-3
.