Table of Contents
Advertisement
Inputting Camera Images
2-1-(9)
The initial Calibration Screen will be displayed.
Calibration(Camera0)
3.
Select Specifying point.
The Specifying Point Screen for the 1st point and a cursor for specifying
the point will be displayed.
Specifying point
4.
Use the Up/Down and Right/Left Keys to move the cursor to the position
to be specified and press the ENT Key.
The screen for inputting coordinates will be displayed.
Specifying point
5.
Input the coordinates for the point to be specified and select End.
The coordinates for the 1st point will be set and the Specifying Point
Screen for the 2nd point will be displayed.
6.
Repeat steps 4 and 5 and specify 2 or more points.
Once point specification has been completed, a confirmation message will
be displayed.
7.
Select Execute.
Sampling input
Specifying point
Specifying coordinate axis
Parameter input
Reference parameter
Specifying point
X : [ 0.000]
Y : [ 0.000]
End
Registering calibration
Parameters
Execute
Cancel
Section 2-1
1st point
405,101
+
1st point
+
Advertisement
Chapters
Table of Contents
