Omron F250-UME Software Manual page 553

ECM Search
2-23-10 Measurement Screens
SeeAlso
CHECK
Measurement Values and Positions
Matching Edges
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for ECM
searches.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Use the Up or Down Key to change to the unit for which ECM search is set
and the following detailed screens will be displayed.
Use the SHIFT+Right or Left Keys to switch in order between the two
screens.
0.Scn 0 RUN
1.ECM search
Judge :OK
EC corr. :86
Pos. X :236.000
Pos. Y :256.000
If Detailed conditions/Matching edges is set to ON, the following screen will be
displayed.
0.Scn 0 RUN
1.ECM search
RUN NG
Image status
:
Freeze(Before scroll)
Display image
:Image0
Image size
: All
Display results
: Details
End
Image 0 Freeze
OK 45ms
Model frame and search coordinates
displayed in OK color for OK judgements
and displayed in NG color for NG
judgements.
Search coordinates
Search region
OK 45ms
The matching edges will be shown in the
OK color for OK judgement results and in
the NG color for NG results.
Section 2-23
for details on Monitor and
67ms
2-23-(26)