Table of Contents
Advertisement
EC Circle Count
2-19-7
Setting Detailed Conditions
CHECK
SeeAlso
Detailed conditions
Skipping
Circular value
Radius
[ 1.000:512.000]
Set the radius for circles to be counted. (1.000 to 9999.999 (1.000 to 512.000*))
Candidate circles that do not fall within this radius range are not counted.
Adjust the detailed conditions if the circle detection is unstable or if circles of
different sizes are counted.
Finding Circles
1.
Extracting Circle Candidates
Size: Set under Candidate radius.
Refer to page 2-19-(10).
Extraction: Performed based on pixel skipping setting.
2.
Judging Whether or Not Candidate Circle Should Be Counted
Deformity check: Is the circle within the circular value range?
Size check:
:
ON
:
[ 0]%
:
Circle deformity check (0 to 100 (0*))
End
If the circle is deformed or chipped, the evaluation is
lower. Any figure with an evaluation lower than the setting
here will not be counted as a circle.
The asterisk (*) indicates the default setting.
1.
Select Detailed conditions.
1.EC circle count
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
Is the circle within the radius range?
Select whether pixel skipping (1 pixel) will be used
when searching for circle candidates. (ON*, OFF)
Processing is faster if pixel skipping is ON and normally
it is appropriate to set pixel skipping to ON. However, if
the measurement values vary, set to OFF.
Measurement image
Extract edges
Measurement conditions
Inspected region
Candidate radius
Judgement conditions
Detailed conditions
Coordinate mode
Skipping
:
ON
Circular value
:
[ 0]%
Radius
:
[ 1.000:512.000]
End
Section 2-19
2-19-(14)
Advertisement
Chapters
Table of Contents
