Omron F250-UME Software Manual page 566

Lot Number OCV 1
STEP 6: Setting Noise Removal Conditions
CHECK
2-24-(13)
The Dilate Level Settings Screen will be displayed.
Dilate level
2. Move the cursor to the level value and use the Left and Right Keys to
change the value (0 to 9).
Right Key: Increases the level by one.
Left Key: Decreases the level by one.
3. After the dot have joined, select OK.
The settings will be registered and the screen in (1.) will return.
Set the conditions for ignoring noise when executing number extraction.
The noise removal settings are enabled only for regions for which automatic
extraction is selected under Measurement conditions/Extract method.
1. Select Noise conditions.
Extract conditions
Compensate image
Shading
Binary
Extract method
Dilate level
Noise conditions
The Noise Conditions Settings Screen will be displayed.
Noise conditions
2. Change the conditions.
3. Select End.
The settings will be registered and the screen in (1.) will return.
Level:[
:
End image
Leave
:
Horizontal noise
[ 5]
:
Noise height
[ 0]
:
Vertical noise
[ 2]
:
Noise width
[ 0]
End
Section 2-24
0 ]
OK