Capturing And Saving Images - Omron F250-UME Software Manual

Customizing Operations
5-4-2

Capturing and Saving Images

CHECK
SeeAlso
Execution Keys
CHECK
Turn ON the display capture function to capture the image displayed on the
monitor screen and save it to the Memory Card.
Stored images can be pasted to documents on a personal computer or loaded
to the Controller and re-measured.
The default setting is OFF.
• The capture operation takes several seconds, during which measurement
cannot be performed. To prevent incorrect operation, set this function to
OFF.
• When the image display is set to Last NG, captured images are not
accepted.
1. Enter System mode and select Operation settings.
Refer to
The Menu will be displayed.
2. Select Display capture.
The Display Capture Screen will be displayed.
Display capture
3. Set the display capture function to either ON or OFF.
4. Select the destination output Memory Card drive.
5. Select End.
The settings will be registered and the screen in (1.) will return.
The following keys execute display capture when the display capture function
is turned ON.
• For F160-KP: F9 Key
• For F150-KP: SHIFT+Left+Right Keys (Press 3 keys at the same time.)
In Monitor and Run Modes only, the display capture function can be allocated
to another key. For example, the key allocation can be changed when the
F150-KP is being used to enable one-touch operation, rather than having to
press three keys at the same time. However, if display capture is allocated to
another key, care must be taken because that key will be enabled in Monitor
and Run Modes even if Display capture is set to OFF. Refer to
.
.
Set key operation
Display capture
Save at switch Scn Group
Password
Nonstop/Fast
Display capture :
OFF
Output drive :
C1
End
Section 5-4
5-(21)