Omron F250-UME Software Manual page 434

Edge Position
2-17-4 Measurement Screens
SeeAlso
CHECK
Judgement Result
List of Positions
2-17-(13)
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for edge
positioning.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Use the Up or Down Key to change to the unit for which edge positioning is
set and the following detailed screens will be displayed.
Use the SHIFT+Right or Left Keys to switch in order between the two
screens.
0.Scn 0 RUN
1.Edge position
Judge:OK
0
+
Region number
A list of edge positions for each region will be displayed.
0.Scn 0 RUN
1.Edge position
Pos.X
0. 90.785
1.
2.
3.
4.
5.
6.
7.
RUN
Image status
:
Freeze(Before scroll)
Display image
: Image0
Image size
:
Display results
: Details
End
OK 45ms
Judgement result for this unit
Inspection region displayed in OK
color for OK result and displayed in
NG color for NG result.
Edge position
NG 45ms
Pos.Y
125.251
NG regions will be highlighted.
Region number
Section 2-17
for details on Monitor and
All