Omron F250-UME Software Manual page 523

Rotation Positioning
2-22-3 Changing Detailed Conditions
Use this operation to change the search-related settings. Change the condi-
tions if the measurement results are unstable. Normally, however, the default
settings are sufficient.
Once the settings have been changed, check that actual measurement is per-
formed correctly.
1. Select Rotate position.
0.Scn 0=SET=
0.Camera image
1.Rotate position
2.
A list of settings selections will be displayed.
1.Rotate position
2. Select Detailed conditions.
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
3. Change the settings.
4. Select End.
The settings will be registered and the screen in (1.) will return.
Measurement conditions
Select region
Detailed conditions
A
Coordinate mode
Verification : OFF
Candidate level : [ 60]
End
Section 2-22
2-22-(18)