Table of Contents
Advertisement
Labeling
2-25-4
Drawing Measurement Regions
CHECK
When a measurement region is drawn, measurement is performed for the dis-
played image and the results are registered as the reference values (area and
the position of center of gravity of the label number specified under Measure-
ment conditions).
Regions can be created by combining up to 3 different figures. Regions with
difficult shapes can be drawn and sections not to be measured can be left out
of the region by combining different figures.
1.
Select Region.
The Region Settings Screen will be displayed.
Region
New
E
2.
Select New.
3.
Select the shape of the desired figure.
4.
Select the desired drawing mode (OR/NOT).
An arrow cursor will appear.
Region
5.
Draw a figure in the region to be measured.
Measurement image
Binary
Measurement conditions
Region
Reference registration
Judgement conditions
Coordinate mode
Box
Ellipse
OR
Circle
NOT
Circumference
Polygon
Up to three figures (0, 1, and 2) can be drawn.
[0]
375,341
Section 2-25
2-25-(8)
Advertisement
Chapters
Table of Contents
