Table of Contents
Advertisement
Edge Position Compensation
2-7-2-5
STEP 5: Changing Detailed Conditions
The Judgement Conditions Settings Screen will be displayed.
Judgement conditions
2.
Change the settings.
3.
Select End.
The settings will be registered and the screen in (1.) will return.
Change the detailed conditions when the measurement results are unstable.
Normally, these conditions can be left on the default settings. After changing
the settings, perform an object measurement to check that measurement can
still be performed correctly.
1.
Select Detailed conditions.
Position compensation 0
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
2.
Change the settings.
Refer to the information on edge level, noise level, and noise width below
for details.
3.
Select End.
The settings will be registered and the screen in (1.) will return.
Position X:
95.000
[
0.000:
511.000
Position Y:
95.000
[
0.000:
483.000 ]
End
Measurement conditions
Region
Reference registration
Judgement conditions
Detailed conditions
Clear
Edge level :[ 50]%
Noise level :[ 20]
Noise width:[ 0]pix
End
Section 2-7
]
2-7-(7)
Advertisement
Chapters
Table of Contents
