Omron F250-UME Software Manual page 909

Normal Serial Interface
Note If these settings are changed, one rectangular region will be set and any previ-
CHECK
Note These values are output in pixels regardless of the calibration setting. This is
Data
The following data is the inspection region parameters for defect (deviation).
264 Region 0
265
266 Region 1
to
770 Region 7
to
852
853
ously drawn figures will be deleted. This is true for regions 1 to 7 as well.
Only the allocations for region 0 are listed here. Refer to the allocations for
region 0 to calculate the numbers for regions 1 to 7.
EC Defect (Measurement Data)
Data
Measure- 0 Judgement result
ment
-2: Not measured.
data
-1: NG
0: OK
1 Region 0
2
3
4
5
6
7
8 Region 1
to
50 Region 7
51
52
53
54
55
56
true for regions 1 to 7 as well.
Details
Deviation reference position X (0 to 511)
Deviation reference position Y (0 to 483)
Large defect flag
0: OFF
1: ON
... (Same as for region 0)
Large defect flag
0: OFF
1: ON
... (Same as for region 0)
Deviation reference position X (0 to 511)
Deviation reference position Y (0 to 483)
Details
Judgement
Defect width (See note.)
Defect length (See note.)
Gravity X
Gravity Y
Area
Number of labels
Judgement
... (Same as for region 0)
Judgement
Defect width (See note.)
Defect length (See note.)
Gravity X
Gravity Y
Area
Number of labels
Section 6-2
6-2-(59)