Set Unit Data - Omron F250-UME Software Manual

Set Unit Data

2-33 Set Unit Data
2-33-(1)
The Set Unit Data processing item is used to replace data during measure-
ment with processing item data (e.g., set parameters) set in the flowchart.
Example: Adjusting Search Regions According to Measurement Object Size
0.Scn 0=SET=
0.Camera image
1.Edge position
2.Set unit data
3.Set unit data
4.Set unit data
5.Set unit data
6.Classification
7.
• Detects outline of measurement object in regions 0 to 3 of [1. Edge posi-
tion].
• Adjusts the search region for [6. Classification] based on that result.
Upper left Y coordinate for search region for [6. Classification]
replaced with the detected Y coordinate.
Region 0
Upper left X coordinate for
search region for [6.
Classification] replaced with
the detected X coordinate.
Lower right Y coordinate for search region for [6. Classification]
replaced with the detected Y coordinate.
Region 1
A A
Region 2
Lower right X coordinate for
search region for [6.
Classification] replaced with
the detected X coordinate.
Region 3
Section 2-33