Omron F250-UME Software Manual page 493

QUEST Character Verification
CHECK
SeeAlso
1. Select Inspected region.
Region0
An arrow cursor will appear.
Inspected region
2. Draw a rectangular inspected region.
Specify the upper left and lower right coordinates.
Up/Down/Left/Right Keys: Move the cursor.
ENT Key:
Draw the region so that only the target characters fall within the region. Use
End Image to remove anything other than the target characters that over-
lap either vertically or horizontally on the inspection region.
Refer to page 2-21-(13).
Only edges that overlap either vertically or horizontally can be removed. If
the edges overlap both vertically and horizontally, the characters cannot be
extracted correctly. If the edges overlap in both directions, adjust the posi-
tion and size of the extracting region so that only the characters to be ex-
tracted fall within the extracting region.
Incorrect
KB-65767
01.11.07
When the bottom right coordinates have been set, the screen in (1.) will re-
turn.
Mode
Inspected region
Set string
K B - 6 5 7 6 2
Clear
0 1 . 1 1. 0 7
K B - 6 5 7 6 2
0 1 . 1 1. 0 7
Confirms the settings.
Adjust size of extracting region.
Section 2-21
412,190
Correct
KB-65767
01.11.07
2-21-(24)