Omron F250-UME Software Manual page 670

Trend Monitor
2-34-5 Changing Detailed Conditions
Detailed conditions
: [
Recording interval
:
Warning count [
:
Display average
:
Display maximum
:
Display minimum
:
NG by warning OFF
:
Graph line 2dot
End
Note
2-34-(14)
The items displayed on the Trend Monitor and the timing of warnings can be
changed. Change these detailed conditions as required.
Specify an interval between 1 and 99,999 (1*) for recording
values for the graph, i.e., the number of measurements
before a value is recorded. (See note 1.)
Specify the number of times the measurement must fall in
the warning range before a warning is generated. (1 to 999
(1*)) (See note 2.)
1]
Select whether or not to display the average for the number of
1]
measurements set under recording interval. (ON*, OFF)
ON
ON
Select whether or not to display the maximum and minimum
ON
for the number of measurements set under recording interval.
(ON*, OFF)
Select whether or not to set the judgement for this unit to NG
if a warning is generated. (ON, OFF*)
Specify the width of graph lines (1 dot, 2 dot*)
Lines are finer if set to 1 dot and processing time is faster
than if 2 dot is set.
The asterisk (*) indicates the default setting.
1. If the recording interval is set to 2 or higher, the minimum and maximums
for that interval will be displayed as shown in the following diagram.
0.Scn 0 RUN
450.000
400.000
350.000
Meas. : 226.000
Judge : NG Warning
2. If the warning count is set to 2 or higher, Warning will appear on the screen
if the measurement result enters the warning range continuously that num-
ber of times or more.
No warning display the first time.
Upper
judgement limit
Warning range
(upper limit)
Maximum displayed in OK color.
Average displayed in NG color.
Minimum displayed in OK color.
Disp.200
The measurement value is updated for
each measurement, regardless of the
recording interval.
Warning appears on the screen
when measurement result enters
warning range continuously for the
number of times set to warning
count or more.
Section 2-34