Omron F250-UME Software Manual page 220

Circle Position Compensation
CHECK
2-9-(17)
8. Specify the size of the circle.
Left Key: Decreases the size.
Right Key: Increases the size.
9. Press the ENT Key.
The screen for registering the width will be displayed.
Model registration
10. Specify the width.
Right/Up Keys:
Left/Down Keys:
11. Press the ENT Key.
If Defect (Arc) has been selected, a screen for specifying the start and end
points of the arc will be displayed.
If Defect (Circle) has been selected, move to (13.).
Model registration
12. Specify the start and end points of the arc, keeping in mind the rotation an-
gle.
A confirmation screen will be displayed.
A display cursor will appear at the position where the defect has been
detected.
Model registration
13. Check that an appropriate position has been registered as the model.
Increase the width.
Decrease the width.
ENT:Register ESC:Cancel
Section 2-9
20
0,0