Omron F250-UME Software Manual page 226

Circle Position Compensation
CHECK
2-9-(23)
5. Press the ENT Key.
The screen for registering the size of the model will be displayed.
Model registration
6. Adjust the size of the model.
Right Key: Increases the size horizontally.
Left Key: Decreases the size horizontally.
Down Key: Increases the size vertically.
Up Key: Decreases the size vertically.
When the size of model 0 is adjusted, models 1 to 3 will also change to the
same size.
7. Press the ENT Key.
A screen for setting the circle for rotation positioning will be displayed.
Model registration
8. Specify the size of the circle.
Right Key: Increases the size.
Left Key: Decreases the size.
9. Press the ENT Key.
If the number of circles is set to 2 under Detailed conditions, the screen for
drawing another circle will be displayed.
Section 2-9
39,39
70