Omron F250-UME Software Manual page 460

Pattern
CHECK
STEP 2: Changing the Search Coordinates
CHECK
CHECK
2-20-(7)
To re-register a model, repeat the procedure from step 4 of Step 1: Regis-
tering the Model.
Use this function to change the search coordinates only.
When a model is registered, the center position of the model is registered as
the search coordinates. This function can be used to register a point other
than the center of the model as the search coordinates.
The search coordinates are used for the point output as the measurement
value. The search coordinates can be changed to any point inside the model.
If multiple figures have been combined to create the model, the search coordi-
nates will be limited to the circumscribing rectangle.
Changing the Point Output as the Measurement Value
If the model is re-registered, the search coordinates are changed to the center
position of the new model.
1. Select Search coordinates.
Region0
A cursor will appear in the center position.
Search coordinate
2. To change the position, use the Up/Down and Right/Left Keys to move
the cursor.
3. Press the ENT Key.
The setting will be registered and the screen in (1.) will return.
Search coordinate
changed to a suitable position
(center of model is the default)
Model
Model registration
Search coordinate
Search region
Judgement conditions
Model reference
Clear
Search coordinate
Section 2-20
403,171