Executing Installation - Omron F250-UME Software Manual

Installing the Application Software
1-3-3

Executing Installation

Precaution
This section describes how to install the selected processing items to the Con-
troller.
1. Select Install.
Set up
A confirmation message will be displayed.
2. Select Execute.
The size of the processing items will be calculated to determine if they can
be installed.
If the total size of the selected processing items is too large to be installed,
a confirmation message will be displayed to ask if the files are to be com-
pressed.
Do not input the RESET signal or turn OFF the power supply while the pro-
cessing message is being displayed. If the RESET signal is input or the power
is turned OFF, data may be lost and the Controller may not start correctly the
next time.
A confirmation message will be displayed once the installation has been
completed.
Select items
Install
Backup data load
Clear memory
Selected Programs
will be installed.
The programs and data
stored at present
are cleared.
Execute Cancel
Total size of selected items
is too large to install.
Compressing programs make
the installation possible,
but startup time will
be longer.
Compress programs?
Execute Cancel
To STEP 3 Refer to page 1-(9).
Installation finished.
Put off the memory card
and restart.
OK
Section 1-3
1-(7)