Table of Contents
Advertisement
Density Data
2-28-2
Drawing Measurement Regions
CHECK
Draw the region for which the density is to be found.
Regions can be created by combining up to 3 different figures. Regions with
difficult shapes can be drawn and sections not to be measured can be left out
of the region by combining different figures.
1.
Select Region.
The Region Settings Screen will be displayed.
Region
New
EBox
2.
Select New.
3.
Select the shape of the desired figure.
4.
Select the desired drawing mode (OR/NOT).
An arrow cursor will appear.
Region
5.
Draw a figure in the region to be used as the measurement region.
The figure will be registered.
Measurement image
Region
Judgement conditions
Ellipse
OR
Circle
NOT
Circumference
Polygon
Up to three figures (0, 1, and 2) can be drawn.
[0]
262,231
Once three figures have been drawn,
Add will no longer be displayed.
Region
Add
Figure0
End
Section 2-28
2-28-(4)
Advertisement
Chapters
Table of Contents
