Omron F250-UME Software Manual page 294

Classification
2-13-4 Changing Detailed Conditions
2-13-(11)
Use this operation to change the search-related settings. Change the condi-
tions if the measurement results are unstable. Normally, however, the default
settings are sufficient.
After the settings have been changed, check that actual measurement is per-
formed correctly.
1. Select Classification.
0.Scn 0=SET=
ENT:Set SFT+ESC:Edit
A list of settings selections will be displayed.
1.Classification
2. Select Detailed conditions.
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
3. Change the settings.
4. Select End.
The settings will be registered and the screen in (1.) will return.
0.Camera image
1.Classification
2.
Model registration
Search region
Judgement conditions
Detailed conditions
Coordinate mode
Interpolation :
Verification :
Candidate level :
End
Section 2-13
ON
OFF
[ 60]