Saving Settings And Shutting Down - Omron F250-UME Software Manual

Saving Settings and Shutting Down

1-8 Saving Settings and Shutting Down
Precaution
Precaution
CHECK
1-(64)
Save settings to flash memory before turning the power OFF.
Flash memory data is loaded each time the Controller is started. Therefore,
when settings have been changed, be sure to save then to flash memory
before turning OFF the power. If the power is turned OFF without saving new
settings, all of the setting changes will be lost.
Stored images cannot be saved to flash memory so all stored images will be
cleared when the power is turned OFF. If stored images are to be kept, backup
the images to a personal computer or Memory Card. Refer to SECTION 4
Other Functions.
1. Display the Basic Screen for Monitor Mode or Run Mode.
2. Move the cursor to MON (or RUN) and press the ENT Key.
The mode selections will be displayed.
3. Select SAVE.
A confirmation message will be displayed.
4. Select Execute.
Do not turn OFF the power or input a RESET signal while a message is
being displayed in any save or load operation. Data in memory will be de-
stroyed, and the Controller may not operate correctly the next time it is
started.
Once the setting data has been saved, the screen in (1.) return.
5. Turn OFF the power supply to the Controller to shut down.
Using the Scene Group Function
The scene data set to scene group 0 and the system data will be saved to the
Controller flash memory. If this save operation is executed, the settings data
for scene groups 1 to 31 will be saved to the Memory Card mounted to drive 1.
The Memory Card data will be overwritten.
0.Scn 0 MON
0.Scn 0 MON
SET
MON
RUN
SYS
TOOL
SAVE
Setting data will saved.
Execute Cancel
Section 1-8
---- ---ms
---- ---ms