Omron F250-UME Software Manual page 368

EC Defect
2-15-5-2 Labeling
Original image
Defects
1
Set binary
levels.
STEP 1: Setting Binary Levels
SeeAlso
CHECK
2-15-(35)
Labeling is performed on the removal image. One group of white pixels is
detected as one label. The Controller will judge whether or not labels that
match the set conditions are defects.
Circle
removed
2 3
Set Set
measurem inspection
ent region.
Adjust the binary levels so that the area to be measured appears as white pix-
els.
1. Display the measurement method selections using the same steps 1 to 3
as outlined under Defect.
Refer to page 2-15-(32).
New registration(Inspected R0)
2. Select Labeling.
The initial Labeling Screen will be displayed.
3. Select Binary.
The settings screen for binary levels will be displayed.
An edge-extracted image (the original image with edge extraction) is dis-
played. When Switch image is selected, the removal image will be
Removal image
1 label
4
Set
judgement
conditions.
Defect
Labeling
Gravity and area
Binary
Measurement conditions
Inspected region
Judgement conditions
Clear
Section 2-15
1 label
Inspection region