Omron F250-UME Software Manual page 556

Lot Number OCV 1
2-24-1 Selecting Measurement Images
CHECK
2-24-(3)
This section describes how to select an image stored at either Image 0 or
Image 1 as the image for measurement.
1. Select Lot-No. OCV1.
0.Scn 0=SET=
0.Camera image
1.Lot-No. OCV1
2.
ENT:Set SFT+ESC:Edit
The setting selections will be displayed.
2. Select Measurement image.
The selections will be displayed.
Measurement image
3. Select which image will be used for measurement, the image stored at Im-
age 0 or the image stored at Image 1.
4. Press the ENT Key.
The settings will be registered and the screen in (1.) will return.
If Shading is set under Extract conditions (i.e., the shading level has been set
to 1 or higher), the image selected here will be dilated or eroded and stored at
the other image number. Set Change Filtering as the next processing item to
use this image for measurement for units after the unit for which Lot Number
OCV1 was set. Then store the image stored in the image buffer to Image 0 or
Image 1.
Measurement image
Extract conditions
Font
Measurement conditions
Reference date
Inspected region
Judgement conditions
Reference number
Image0
Image1
Section 2-24