Omron F250-UME Software Manual page 176

EC Position Compensation
Position Display
Display By Region
Example: Cross point
Measurement value display
0.Scn 0 RUN
1.EC pos. comp
Position0(Cross point)
Judge :OK
:213.124
PositionX
:268.369
PositionY
: 90.236
Length 1 : 50.513
: 51.368
Length 2
2-6-(38)
Only the search region will be displayed.
0.Scn 0
1.EC pos. comp
More detailed measurement results will be displayed for each region.
Each time the SHIFT+Right or SHIFT+Left Keys are pressed, the set regions
will be displayed in order.
• Circles
0.Scn 0 RUN
1.EC pos. comp
Position0 (Circle)
:OK
Judge
:213.124
PositionX
:268.369
PositionY
:150.236
Radius
:85
Value
• Cross Points, Boxes, and Multi-points
After the measurement value for the region is displayed, a screen will be
displayed so the line extraction status can be confirmed.
OK 45ms
OK 45ms
RUN
0
OK 45ms
Outline of target figure
Screen where line extraction
status can be confirmed
0.Scn 0 RUN
1.EC pos. comp
Position0(Cross point)
All lines are displayed.
Section 2-6
OK 45ms