Omron F250-UME Software Manual page 868

Normal Serial Interface
6-2-2-11 MEASOUT: Measure Out
Function 1
Function 2
6-2-2-12 MEASURE (M)
Function 1
6-2-(18)
Confirms the mode of the Controller: Monitor (results not output) or RUN
(results output).
Input
MEASOUT Delimiter
Output
Command executed correctly:
Command not executed correctly:
• Mode numbers are as follows:
Mode
number
0 Monitor (results not output)
1 RUN (results output)
Example
This example indicates that the Controller is in Run Mode.
Input MEASOUT Delimiter
Output 1 Delimiter
OK Delimiter
Changes the mode of the Controller: Monitor (results not output) or RUN
(results output).
Input
MEASOUT <Mode number> Delimiter
• Refer to Function 1 for mode numbers.
Output
Command executed correctly:
Command not executed correctly:
Example
This example changes the Controller to Run Mode.
Input MEASOUT 1 Delimiter
Output OK Delimiter
Executes one measurement.
Input
MEASURE Delimiter
Output
Command executed correctly:
Command not executed correctly:
Mode number Delimiter
OK Delimiter
ER Delimiter
Mode
OK Delimiter
ER Delimiter
Measurement result Delimiter
OK Delimiter
ER Delimiter
Section 6-2