Backing Up Data - Omron F250-UME Software Manual

Backing Up Data

4-2 Backing Up Data
CHECK
Precaution
This section explains how to make backup copies of data to flash memory or a
computer.
When the power to the Controller is turned OFF, all data settings are cleared.
The Controller loads data saved to flash memory at startup. Therefore, when
settings are changed, in order not to lose these settings, be sure to save them
to flash memory.
The 5 types of system and scene data listed below can be backed up on a
computer or Memory Card. This function is convenient for using the same set-
tings on another Controller.
It is recommended that data is backed up in case data is lost or the Controller
malfunctions.
Data
System data Settings under SYS are backed up to a computer or Memory
Card.
Scene group data Scene data (scenes 0 to 31) for specified scene group are
backed up to a computer or Memory Card.
Scene data Settings under SET are backed up to a computer or Memory
Card.
System data and Both the system data and scene group data (for the scene group
scene group data currently displayed) are backed up together to a computer or
Memory Card.
Image data Saved measurement images in BMP format are backed up to a
computer or Memory Card. This is the basic image format for
Windows and so the images can be displayed on a personal com-
puter.
When backing up images saved when Frame was selected for the Frame/Field
mode, save those images while displaying frame images.
When backing up images saved when Field was selected for the Frame/Field
mode, save those images while displaying field images.
Do not turn OFF the power or input a RESET signal while a message is being
displayed in any save or load operation. Data in memory will be destroyed, and
the Controller may not operate correctly the next time it is started.
Section 4-2
Contents
4-(9)