Omron F250-UME Software Manual page 900

Normal Serial Interface
Measurement
Note The upper left and lower right coordinates of the calculated measurement
6-2-(50)
Binary Defect (Measurement Data)
Data
Measure- 0 Judgement result
ment
-2: Not measured.
data
-1: NG
0: OK
1 Region 0
2
3
4
5
6
7
8
9
10
11
12
13
14
15 Region 1
to
99 Region 7
to
111
112
region will be output whenever Area (Variable Box) is set for any of the regions
0 to 7. These coordinates will be output in pixels regardless of the setting for
calibration.
Binary Defect (Settings Data)
Data
Settings 120 Measurement image
data
0: Image 0
1: Image 1
121 Coordinate mode
0: After scroll, calibration OFF
1: Before scroll, calibration OFF
2: After scroll, calibration ON
3: Before scroll, calibration ON
122 Binary level (common) upper limit (0 to 255)
123 Binary level (common) lower limit (0 to 255)
124 Reverse binary level (common)
0: Not reversed
1: Reversed
Details
Judgement result
Region X 1 (See note.)
Region Y 1 (See note.)
Region X 2 (See note.)
Region Y 2 (See note.)
Gravity X
Gravity Y
Axis angle
Area
Reversed area
Reference position X
Reference position Y
Reference angle
Reference area
Judgement result
... (Same as for region 0)
Judgement result
... (Same as for region 0)
Reference angle
Reference area
Details
Section 6-2