Omron F250-UME Software Manual page 452

EC Circle Count
2-19-9 Measurement Screens
SeeAlso
CHECK
Judgement Result
Circle Information (Center Position and Radius)
2-19-(17)
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for EC circle
count.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Use the Up or Down Key to change to the unit for which EC circle count
inspection is set and the following detailed screens will be displayed.
Use the SHIFT+Right or Left Keys to switch in order between the three
screens.
0.Scn 0 RUN
1.EC circle count
Judge :NG
Quantity:4
0.Scn 0 RUN
1.EC circle count
CenterX CenterY Radius
0. 81.263 253.120
1.198.962 254.612
2.392.861 251.961
3. 81.263 435.564
4.198.962 435.612
5.392.861 434.961
RUN
Image status
:
Freeze(Before scroll)
Display image
: Image0
Image size
: All
Display results
: Details
End
NG 45ms
The measurement result for this unit (In
this example, when number of circles set to
6 under Judgement conditions.)
No. of circles found.
NG radius
The display cursor is shown in NG color.
NG circular value
The circumference is shown in NG color.
NG 45ms
21.021
Displays detailed information
20.946
for candidate circles.
20.634
Use the center X and center Y
11.021
information to determine which
20.986
circle the information is for.
20.634
Section 2-19
for details on Monitor and