Omron F250-UME Software Manual page 873

Normal Serial Interface
CHECK
6-2-2-21 SCNSAVEM: Scene Save Memory Card
Function
6-2-2-22 SCNGROUP: Scene Group
Function 1
Output
Command executed correctly:
Command not executed correctly:
The XMODEM (-1K) protocol is not supported.
Example
This example saves the scene 2 scene data to the external device.
Input SCNSAVE 2 Delimiter
Output OK Delimiter
Saves scene data to a Memory Card.
Input
SCNSAVEM <scene number> <file name> Delimiter
• Specify a scene number between 0 and 31.
• Specify the drive (C0 or C1) at the beginning of the file name.
• Specify the absolute path from the root directory.
• Add the filename extension .SCN to the filename.
Output
Command executed correctly:
Command not executed correctly:
Example
This example saves the scene 2 scene data as file "LABEL.SCN" in Memory
Card 0 directory DIR01.
Input SCNSAVEM 2 /C0/DIR01/LABEL.SCN Delimiter
Output OK Delimiter
Reads the scene group number being used.
Input
SCNGROUP Delimiter
Output
Command executed correctly:
Command not executed correctly:
Example
In this example, scene group 0 is being used.
Input SCNGROUP Delimiter
Output 0 Delimiter
OK Delimiter
OK Delimiter
ER Delimiter
OK Delimiter
ER Delimiter
Scene group number Delimiter
OK Delimiter
ER Delimiter
Section 6-2
6-2-(23)