Enabling Or Disabling Rmon Probes - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Diagnosing Switch Problems

Enabling or Disabling RMON Probes

To enable or disable an individual RMON probe, enter the
specify the type of probe (stats/history/alarm), followed by the entry number (optional), as shown in the
following examples.
The following command enables RMON Ethernet Statistics probe number 4012:
-> rmon probes stats 4012 enable
The following command disables RMON History probe number 10240:
-> rmon probes history 10240 disable
The following command enables RMON Alarm probe number 11235:
-> rmon probes alarm 11235 enable
To enable or disable an entire group of RMON probes of a particular flavor type (such as Ethernet
Statistics, History, or Alarm), enter the command without specifying an entry-number, as shown in the
following examples.
The following command disables all currently defined (disabled) RMON Ethernet Statistics probes:
-> rmon probes stats disable
The following command enables all currently defined (disabled) RMON History probes:
-> rmon probes history enable
The following command enables all currently defined (disabled) RMON Alarm probes:
-> rmon probes alarm enable
Note. Network activity on subnetworks attached to an RMON probe can be monitored by Network
Management Software (NMS) applications.
OmniSwitch AOS Release 8 Network Configuration Guide
rmon probes CLI command. Be sure to
December 2017
Remote Monitoring (RMON)
page 34-30