Diagnosing Switch Problems
RMON Probe Defaults
The following table shows Remote Network Monitoring default values.
Global RMON Probe Defaults
Parameter Description
RMON Probe Configuration
Quick Steps for Enabling/Disabling RMON Probes
1
Enable an inactive (or disable an active) RMON probe, where necessary. You can also enable or
disable all probes of a particular flavor, if desired. For example:
-> rmon probes stats 1011 enable
-> rmon probes history disable
2
To verify the RMON probe configuration, enter the
for the type of probe. For example, to display the statistics probes, enter the following:
-> show rmon probes stats
The display is similar to the one shown below:
Entry
Slot/Port
-------+----------+---------+-----------+------------+----------------
1011
1/11
3
To view statistics for a particular RMON probe, enter the show rmon probes command, with the
keyword for the type of probe, followed by the entry number for the desired RMON probe. For example:
-> show rmon probes 1011
The display appears similar to the one shown below:
Probe's Owner: Switch Auto Probe on Slot 1, Port 11
Entry
1011
Flavor = Ethernet, Status = Active,
Time = 11930 hrs 26 mins,
System Resources (bytes) = 272
For more information about these commands, see
"Displaying Statistics for a Particular RMON Probe" on page
in the OmniSwitch CLI Reference Guide.
OmniSwitch AOS Release 7 Network Configuration Guide
CLI Command
rmon probes
Flavor
Status
Ethernet
Active
"Displaying a List of RMON Probes" on page
Remote Monitoring (RMON) Overview
Default Value/Comments
No RMON probes configured.
show rmon probes
command, with the keyword
Duration
System Resources
11930:27:05
272 bytes
26-38, or the "RMON Commands" chapter
March 2011
26-37,
page 26-11