Sflow Receiver - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

sflow receiver

sflow receiver
Sets the destination hosts where the sFlow datagrams are sent out. If there are multiple destinations, then
each destination has an instance of the receiver. All these receivers are attached to the sFlow manager
instance and to an associated sampler/poller.
sflow receiver receiver_index {name string | timeout { seconds | forever} | address {ip_address |
ipv6address} | udp-port port | packet-size size Version num | release}
Syntax Definitions
receiver_index
string
seconds | forever
ip_address| ipv6address
port
size
num
Defaults
parameter
string
seconds
ip_address
port
size
version num
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the release form at the end of the command to delete a receiver.
Examples
-> sflow receiver 1 name Golden Rcvr1 address 198.206.181.3
-> sflow receiver 1 release
Release History
Release 7.1.1; command was introduced.
page 32-4
Specifies the receiver index.
Specifies the name.
Specifies the timeout value.
Specifies the 32/128-bit ip address.
Specifies the UDP (destination) port.
Specifies the maximum number of data bytes (size) that can be sent.
Specifies the version number.
default
empty
0
0.0.0.0(ipv4)
6343
1400
5
OmniSwitch CLI Reference Guide
sFlow Commands
March 2011