Module Stop Control Register (Mstpcr) - Renesas Hitachi H8S/2194 Series Hardware Manual

17.2.8

Module Stop Control Register (MSTPCR)

7
Bit :
MSTP15
Initial value :
0
R/W :
R/W
The MSTPCR consists of twin 8-bit read/write registers and it works to control the module stop
mode.
When the MSTP10 bit is set to 1, the Timer X1 stops its operation at the ending point of the bus
cycle to shift to the module stop mode. For more information, see section 4.5, Module Stop
Mode.
When reset, the MSTPCR is initialized to H'FFFF.
Bit 2: Module Stop (MSTP10)
This bit works to designate the module stop mode for the Timer X1.
MSTPCRH
Bit 2
MSTP10 Description
0 Cancels the module stop mode of the Timer X1
1 Sets the module stop mode of the Timer X1
MSTPCRH
6 5 4 3 2
MSTP14 MSTP13 MSTP12 MSTP11 MSTP10
0 1 1 1 1
R/W R/W R/W R/W R/W
1 0 7 6 5
MSTP9 MSTP8 MSTP7 MSTP6 MSTP5
1 1 1 1 1
R/W R/W R/W R/W R/W
Rev. 2.0, 11/00, page 375 of 1037
MSTPCRL
4 3 2 1
MSTP4 MSTP3 MSTP2 MSTP1 MSTP0
1 1 1 1
R/W R/W R/W R/W R/W
(Initial value)
0
1