Module Stop Control Reigster (Mstpcr) - Renesas Hitachi H8S/2194 Series Hardware Manual

28.17

Module Stop Control Reigster (MSTPCR)

Bit : 7
MSTP15
Initial value : 1
R/W :
R/W
MSTPCR comprises two 8-bit readable/writable registers, that perform module stop mode
control. When the MSTP1 bit is set to 1, servo circuit and 12-bit PWM stop the operation at the
end of the bus cycle and enter to the module stop mode. For details, see 4.5 Module stop mode.
MSTPCR is initialized to H'FFFF by a reset.
Bit 1: Module Stop 1 (MSTP1)
This bit specifies module stop mode of the servo circuit and 12-bit PWM.
MSTPCRL
Bit 1
MSTP1 Description
0 Clear the module stop mode of the Servo Circuit and 12-bit PWM
1 Set the module stop mode of the Servo Circuit and 12-bit PWM
MSTPCRH
6 5 4 3
MSTP14 MSTP13 MSTP12 MSTP11 MSTP10
1 1 1 1
R/W R/W R/W R/W R/W
2 1 0 7 6
MSTP9 MSTP8 MSTP7 MSTP6
1 1 1 1 1
R/W R/W R/W R/W
MSTPCRL
5 4 3 2
MSTP5 MSTP4 MSTP3 MSTP2
1 1 1 1
R/W R/W R/W R/W
(Initial value)
Rev. 2.0, 11/00, page 817 of 1037
1 0
MSTP1 MSTP0
1 1
R/W R/W