Renesas Hitachi H8S/2194 Series Hardware Manual page 810

(3) Operation
During playback, control pulses recorded on the tape are picked up by the control head and
input to the CTL pin. The control pulse signal is amplified by a Schmitt amplifier, reshaped,
then input to the CTL frequency divider as the PB-CTL signal.
This circuit is employed when the control pulse (PB-CTL signal) is used for phase control of
the capstan motor. The divided signal is sent as the DVCTL signal to the capstan phase
system in the servo circuits, and the Timer R.
The CTL frequency divider is an 8-bit reload timer consisting of a reload register and a
down-counter. Frequency division is obtained by setting frequency-division data in bits 7 to
0 in the CTL frequency division register (CTLR), which is the reload register. When a
frequency-division value is written in this reload register, it is also written into the down-
counter. The down-counter is decremented on rising edges of the PB-CTL signal.
Figure 28.64 shows examples of the PB-CTL signal and DVCTL waveforms.
CTL input signal
PB-CTL or external
sync signal
CTLR=00
CTLR=01
CTLR=02
CTLR : CTL frequency division register
Figure 28.64 CTL Frequency Division Waveforms
Rev. 2.0, 11/00, page 783 of 1037