Renesas Hitachi H8S/2194 Series Hardware Manual page 169

(2) On-Chip RAM Area Divisions in Boot Mode
In boot mode, the 2048-byte area from H'FFEFB0 to H'FFF7AF is reserved for use by the
boot program, as shown in figure 7.10. The area to which the programming control program
is transferred is H'FFF7B0 to H'FFFF2F (1920 bytes). The boot program area can be used
when the programming control program transferred into RAM enters the execution state. A
stack area should be set up as required.
Note: * The boot program area cannot be used until a transition is made to the execution
state for the programming control program transferred to RAM. Note that the boot
program reamins stored in this area after a branch is made to the programming
control program.
Rev. 2.0, 11/00, page 142 of 1037
H'FFEFB0
Boot program
(2048 bytes)
H'FFF7B0
Programming
control program
(1920 bytes)
H'FFFF30
Reserved area
(128 bytes)
H'FFFFAF
Figure 7.10 RAM Areas in Boot Mode
area*
area