Renesas Hitachi H8S/2194 Series Hardware Manual page 561

Bit 2: Bus Busy (BBSY)
The BBSY flag can be read to check whether the I
mode, this bit is also used to issue start and stop conditions.
A high-to-low transition of SDA while SCL is high is recognized as a start condition, setting
BBSY to 1. A low-to-high transition of SDA while SCL is high is recognized as a stop
condition, clearing BBSY to 0.
To issue a start condition, use a MOV instruction to write 1 in BBSY and 0 in SCP. A
retransmit start condition is issued in the same way. To issue a stop condition, use a MOV
instruction to write 0 in BBSY and 0 in SCP.
It is not possible to write to BBSY in slave mode; the I
transmit mode before issuing a start condition. MST and TRS should both be set to 1 before
writing 1 in BBSY and 0 in SCP.
Bit 2
BBSY Description
0 Bus is free
[Clearing condition]
When a stop condition is detected
1 Bus is busy
[Setting condition]
When a start condition is detected
2
Bit 1: I C Bus Interface Interrupt Request Flag (IRIC)
2
Indicates that the I C bus interface has issued an interrupt request to the CPU. IRIC is set to 1 at
the end of a data transfer, when a slave address or general call address is detected in slave
receive mode, when bus arbitration is lost in master transmit mode, and when a stop condition is
detected. IRIC is set at different times depending on the FS bit in SAR and the WAIT bit in
ICMR. See section 25.3.6, IRIC Setting Timing and SCL Control. The conditions under which
IRIC is set also differ depending on the setting of the ACKE bit in ICCR.
IRIC is cleared by reading IRIC after it has been set to 1, then writing 0 in IRIC.
When the DTC is used, IRIC is cleared automatically and transfer can be performed
continuously without CPU intervention.
Rev. 2.0, 11/00, page 534 of 1037
2
C bus (SCL, SDA) is busy or free. In master
2
C bus interface must be set to master
(Initial value)