Renesas Hitachi H8S/2194 Series Hardware Manual page 597

(7) Precautions on reading ICDR at the end of master receive mode
When terminating the master receive mode, set TRS bit to 1, and select "write" for ICCR
BBSY = 0 and SCP = 0. This forces to move SDA from low to high level when SCL is at
high level, thereby generating the stop condition.
Now you can read received data from ICDR. If, however, any data is remaining on the
buffer, received data on ICDRS is not transferred to ICDR, thus you won't be able to read the
second byte data.
When it is required to read the second byte data, issue the stop condition from the master
receive state (TRS bit is 0).
Before reading data from ICDR register, make sure that BBSY bit on ICCR register is 0, stop
condition is generated and bus is made free.
If you try to read received data after the stop condition issue instruction (setting ICCR's
BBSY = 0 and SCP = 0 to write) has been executed but before the actual stop condition is
generated, clock may not be appropriately signaled when the next master sending mode is
turned on. Thus, reasonable care is needed for determining when to read the received data.
After the master receive is complete, if you want to re-write I
MST bit) for switching the sending/receiving mode or modifying settings, it must be done
during period (a) indicated in figure 25.18 (after making sure ICCR register BBSY bit is
cleared to 0).
SDA Bit 0
SCL 8
Internal clock
BBSY bit
Master receive mode
Figure 25.18 Precautions on Reading the Master Receive Data
Rev. 2.0, 11/00, page 570 of 1037
A
9
ICDR read
inhibit period
The stop condition
issue instruction
(BBSY = 0 and SCP = 0
set to write) is executed
2
C control bit (such as clearing
Stop condition
(a)
Generation of the stop
condition is checked
(BBSY = 0 is set to read)
Start
condition
Start condition
is issued