Nat Hairpin In P2P Mode For Access Between Internal Users - H3C MSR 2600 Configuration Manual

VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
State: TCP_ESTABLISHED
Application: HTTP
Start time: 2012-08-15 14:53:29
Interface(in) : GigabitEthernet1/1
Interface(out): GigabitEthernet1/1
Initiator->Responder:
Responder->Initiator:
Total sessions found: 1

NAT hairpin in P2P mode for access between internal users

Network requirements
In the P2P application, internal clients must register their IP address to the external server and the server
records the registered IP addresses and port numbers of the internal clients. An internal client must
request the IP address and port number of another client from the external server before accessing the
client.
Configure NAT hairpin so that:
• The internal clients can register the same external address to the external server.
The internal clients can access each other through the IP address and port number obtained from
•
the server.
Figure 59 Network diagram
Configuration considerations
This is a typical application of NAT hairpin in P2P mode.
Configure outbound dynamic NAT on the interface that connects the external network so that the
•
source address of the clients are translated when they register their IP addresses to the external
server.
Configure PAT of the Endpoint-Independent Mapping mode. The translation of the clients'
•
addresses is endpoint-independent because the registered IP address and port number should be
accessible for any source address.
• Enable NAT hairpin on the interface that connects the internal network so that internal clients can
access each other through the external address.
TTL: 3597s
7 packets 308 bytes
5 packets 312 bytes
144