Aaa Timeout - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

aaa timeout

To set the default idle timeout:
Syntax
aaa timeout idle idleTimeout
no aaa timeout idle
To set the default session timeout:
aaa timeout session sessionTimeout
no aaa timeout session
To enable monitoring of only ingress traffic for the configured idle timeout period:
aaa timeout idle ingress-only
no aaa timeout idle [ ingress-only ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
ingress-only keyword added in JUNOSe Release 9.3.0.
Sets the default idle timeout or session timeout for B-RAS PPP users, and optionally
Description
enables the PPP application to monitor only ingress traffic for the configured idle
timeout period to determine whether to disconnect an inactive PPP session. The no
version restores the idle timeout or session timeout to its default value, 0 seconds,
and disables ingress-only traffic monitoring for idle timeout if configured. .
NOTE: To enable ingress-only traffic monitoring for the idle timeout period by issuing
the aaa timeout idle ingress-only command, you must also set the idle timeout
value by issuing the aaa timeout idle command.
Options
Global Configuration
Mode
idleTimeout In seconds, 300–86400
sessionTimeout Time in the range 60–31622400 seconds (that is, a minimum
of 1 minute to a maximum of 366 days); the router terminates the user session
once the maximum session timeout is reached, which means that the duration
of a PPP or an L2TP user session cannot exceed 366 days
ingress-only Enables PPP to monitor only ingress traffic for the configured idle
timeout period to determine whether to disconnect an inactive PPP session; if
you do not specify the ingress-only keyword, PPP monitors both ingress traffic
and egress traffic for the idle timeout period to determine inactivity and
subsequent disconnection of an inactive PPP session
Chapter 2: A Commands
61
aaa timeout