Adapter Enable - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

adapter enable

adapter enable adapterSpecifier
Syntax
Command introduced in JUNOSe Release 7.1.0.
Release Information
Enables the IOA installed in the specified IOA bay. There is no no version.
Description
NOTE: For IOAs that support hot-swapping, issuing this command does not reboot
the line module. For IOAs that do not support hot-swapping, issuing this command
reboots the line module associated with the IOA, but it does not enable it.
To enable the line module and its associated IOAs, issue the slot enable command.
Options
Global Configuration
Mode
adapterSpecifier Particular IOA in the format slot/adapter:
slot Number of the chassis slot; for E120 routers, in the range 0–5; for
E320 routers, in the range 0–5 or 11–16
adapter Identifier for the IOA within the chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
Chapter 2: A Commands
83
adapter enable