Duplex - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
duplex
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
duplex duplexMode
no duplex
Command introduced before JunosE Release 7.1.0.
Specifies the duplex mode for an Ethernet interface. This command works with the speed
command; if you set or accept the automatically negotiate setting for either duplex mode
or speed, the router negotiates both parameters with the remote device. The no version
specifies the default value, automatically negotiate or full duplex (FE-8 SFP I/O module
only). This command is not available for the Ethernet interface on the SRP module.
duplexMode—One of the following duplex options
automatically negotiate—Specifies that the router negotiates duplex mode with the
remote device; not valid for the FE-8 SFP I/O module
full—Specifies that the router uses full duplex on a Fast Ethernet or Gigabit Ethernet
interface
half—Specifies that the router uses half duplex on a Fast Ethernet interface; this
value is not valid for Gigabit Ethernet interfaces
Interface Configuration
Chapter 5: D Commands
549
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers