Ethernet-Service Nni - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ethernet-service nni

ethernet-service nni
Configures the vendor TPID value and the legacy BPDU processing status for a VLAN Stacking Network
Network Interface (NNI).
ethernet-service nni {port slot/port [-port2] | linkagg linkagg_id [-linkagg_id2]} [tpid tpid_value]
[stp legacy-bpdu {enable | disable}]
no ethernet-service nni {port slot/port [-port2] | linkagg linkagg_id [-linkagg_id2]}
Syntax Definitions
slot/port
[-port2]
linkagg_id
[-linkagg_id2]
tpid_value
enable
disable
Defaults
parameter
tpid_value
stp legacy-bpdu enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to disable the ethernet service for the VLAN Stacking NNI ports.
•
This command only applies to ports configured as VLAN Stacking NNI ports.
•
NNI ports can be 802.1q tagged with normal VLANs. In this case, the TPID of the packets tagged with
a normal VLAN must always be 0x8100 (regardless the TPID of the NNI port). This allows NNI port
to carry regular 802.1q tagged traffic as well as SVLAN tagged traffic.
•
Enable legacy BPDU support only on VLAN Stacking network ports that are connected to legacy
BPDU switches. Enabling legacy BPDU between AOS switches can cause flooding or an unstable
network.
page 34-10
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (for example, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
The link aggregate ID.
The last link aggregate ID number in a range of link aggregates that you
want to configure.
Specifies the TPID value of the port.
Enables the specified legacy BPDU support.
Disables the specified legacy BPDU support.
default
0x8100
disable
VLAN Stacking Commands
OmniSwitch CLI Reference Guide March 2011