ethernet-service nni
Configures the vendor TPID value and the legacy BPDU processing status for a VLAN Stacking Network
Network Interface (NNI).
ethernet-service nni {slot/port1[-port2] | agg_num} [tpid value] [{stp | gvrp} legacy-bpdu {enable |
disable}]
Syntax Definitions
slot/port1
-port2
agg_num
value
stp
gvrp
enable
disable
Defaults
parameter
value
stp legacy-bpdu enable | disable
gvrp legacy-bpdu enable | disable
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
This command only applies to ports configured as VLAN Stacking NNI ports.
•
Enable legacy BPDU support only on VLAN Stacking network ports that are connected to legacy
BPDU switches. Enabling legacy BPDU between AOS switches may cause flooding or an unstable
network.
•
If legacy BPDU is enabled on a network port while at same time BPDU flooding is enabled on user
ports, make sure that tagged customer BPDUs are not interpreted by intermediate switches in the
provider network.
page 24-10
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
The link aggregate ID number (0–31).
Specifies the TPID value of the port.
Specifies Spanning Tree legacy BPDU support.
Specifies GVRP legacy BPDU support.
Enables the specified legacy BPDU support.
Disables the specified legacy BPDU support.
default
0x8100
disable
disable
OmniSwitch CLI Reference Guide
VLAN Stacking Commands
November 2009