Port-Monitoring Source - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Port Mirroring and Monitoring Commands

port-monitoring source

Configures a port monitoring session.
port-monitoring port_monitor_sessionid source slot/port
[{no file | file filename [size filesize] | [overwrite {on | off}]}]
[inport | outport | bidirectional] [timeout seconds] [enable | disable] [capture-type {full | brief}]
Syntax Definitions
port_monitor_sessionid
slot/port
file filename
filesize
no file
overwrite on
overwrite off
inport
outport
seconds
enable
disable
full
brief
OmniSwitch CLI Reference Guide
Monitoring session identifier.
Enter the slot number for the module and the physical port number on
that module (for example, 3/1 specifies port 1 on slot 3).
Specifies a file name and pathname for capturing information related to
the monitoring session (for example, /flash/port2.enc).
Specifies the size of the file in 64K byte increments. For
example, a value of 3 would specify a size of (3 x 64K) bytes.
This option is not supported at this time.
Specifies that capturing of data packets into the port monitoring file
continues and old information is overwritten if the total data exceeds the
specified file size.
Specifies that capturing of data packets into the port monitoring file is
stopped when the maximum file size is reached.
Specifies incoming unidirectional port monitoring.
Specifies outgoing unidirectional port monitoring.
Specifies the number of seconds after which the session is disabled.
Enables the port monitoring status.
Disables the port monitoring status.
Captures port monitoring information in detail.
Captures only the concise port monitoring data transmitted.
March 2011
port-monitoring source
page 31-7