Multicast-Suppression - H3C MSR 20-20 Command Reference Manual

182 C 9: C
HAPTER ONFIGURATION
mdi
Syntax
View
Parameter
Description
Example

multicast-suppression

Syntax
View
Parameter
Description
C E
OMMANDS FOR THERNET
mdi { across | auto | normal }
undo mdi
Ethernet interface view
across: Specifies cross-over cables for the Ethernet interface.
auto: Configures the Ethernet interface to be auto-sensing for the cable type.
normal: Specifies straight-through cables for the Ethernet interface.
Use the command to configure the cable type that can be sensed by an
mdi
Ethernet interface.
Use the
undo mdi
By default, an Ethernet interface senses the type of the network cable connected
to it automatically.
n
The optical port of a Combo port does not support this command.
# Configure the interface Ethernet 1/0 to use cross over cable.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mdi across
multicast-suppression { ratio | pps max-pps }
undo multicast-suppression
Ethernet interface view, port group view
ratio: Maximal ratio of multicast traffic to the total transmission capability of an
Ethernet interface, in the range of 1 to 100. Currently, this argument can only be
set to 100.
pps max-pps: Specifies the maximal number of multicast packets passing an
Ethernet interface per second, in pps, representing packets per second. Currently,
the max-pps argument can only be 190, 380, 760, 1488, 2976, 5952, or 11904.
Use the
multicast-suppression
suppression ratio on an interface.
I B M
NTERFACES IN RIDGE ODE
command to restore the system default.
command to configure multicast storm