Fe1 Idlecode; Fe1 Itf - H3C MSR 20-20 Command Reference Manual

236 C 14: E1-F I
HAPTER
Related command:
Example

fe1 idlecode

Syntax
View
Parameter
Description
Example

fe1 itf

Syntax
C C
NTERFACE ONFIGURATION OMMANDS
Only one channel set can be created on an E1-F interface, and this channel set is
associated with the current synchronous serial interface. On a CE1/PRI interface,
however, you may create multiple channel sets; for each of them, the system
automatically creates a synchronous serial interface.
n
Timeslot 0 on E1-F interfaces is used for synchronization. Therefore, a bundling
operation only involves timeslots 1 through 31.
When the E1-F interface is working in unframed mode, the fe1 timeslot-list
command is invalid.
fe1 unframed.
# Bundle timeslots 1, 2, 5, 10 through 15, and 18 on E1-F interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0]fe1 timeslot-list 1,2,5,10-15,18
fe1 idlecode { 7e | ff }
undo fe1 idlecode
E1-F interface view
7e: Sets the line idle code to 0x7E.
ff: Sets the line idle code to 0xFF.
Use the fe1 idlecode
Two types of line idle code are available: 0x7E and 0xFF.
Use the
undo fe1 idlecode
The line idle code is sent in the timeslots that are not bundled into the logical
channels on the interface.
# Set the line idle code to 0x7E on E1-F interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fe1 idlecode 7e
fe1 itf { number number | type { 7e | ff } }
undo fe1 itf { number | type }
command to set the line idle code on the E1-F interface.
command to restore the default, that is, 0x7E.