Display Ft1 - H3C MSR 20-20 Command Reference Manual

15
crc
Syntax
View
Parameter
Description
Example

display ft1

Syntax
View
Parameter
Description
Example
T1-F I
NTERFACE
C
OMMANDS
crc { 16 | 32 | none }
undo crc
Synchronous serial interface view
16: Adopts 16-bit CRC.
32: Adopts 32-bit CRC.
none: Disables CRC.
Use the crc command to configure CRC mode for an T1-F interface.
Use the command to restore the default, that is, 16-bit CRC.
undo crc
# Adopt 32-bit CRC on T1-F interface Serial 1/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] crc 32
display ft1 [ serial interface-number ]
Any view
serial interface-number: Specifies a serial interface. If no interface is specified, the
information on all the T1-F interfaces is displayed.
Use the display ft1 serial
information about a T1-F interface.
If the specified interface is a common serial interface rather than a T1-F interface,
the system will display the prompt.
# Display information about T1-F interface Serial 2/0.
C
ONFIGURATION
command to display the configuration and state